MANY MITTENS - Card 3 of 3 from YouTube Live on September 3, 2019
ft. Many Mittens Dies and Let It Snow Specialty Designer Series Paper
This 3rd mitten card is a combination of the first two cards. It features the Let It Snow specialty DSP, but also features the Sparkle Glimmer Paper used in the second mitten card. Here is a picture of this final mitten card from the 9/3/19 YouTube live:
 |
| Many Mittens Card 3 from YouTube Live 9/3/19 Made by Deb Houck Deb Houck's Crafty Cottage Independent Stampin' Up! Demonstrator (USA) |
 |
| Many Mittens Card 3 - Inside from YouTube Live 9/3/19 Made by Deb Houck Deb Houck's Crafty Cottage Independent Stampin' Up! Demonstrator (USA) |
The dimensions and mats are pretty much the same as Card 1; however, it's been turned landscape like Card 2 instead of Portrait. Also, another Real Red strip was added to the "top" above the mittens. The mittens were done more like Card 1; however, the base mitten was cut out of Real Red card stock and the detailed upper mittens were cut out of the Sparkle Glimmer Paper. Hint: You have to cut one of them from the back of the paper and then flip it over so it will have the Sparkle on the correct side to fit the base.
The sentiment is the same as Card 1. The only difference is that the Coastal Cabana circle was run through the Winter Knit 3D Embossing Folder.
Here are the supplies used to make Mitten Card 3:
Product List
The YouTube Live Stream Videos are Linked Below (both parts). The mittens start at 1:01 in the first video, but may be shown and discussed again in the second part (titled Trying Again...).
No comments:
Post a Comment